monMenu.fr

The sprocket drum should be able to move freely and rotate backwards when the movie is re-wound and due to this fact has to be decoupled from the highest and bottom gear practice. At the highest of a hundred and one is a gear throughout the practice connecting the movie-advance knob to the sprocket drum, that is displaced and so decouples the sprocket drum from the higher gear prepare, the bottom of spindle 101 acts on a disc on spindle 30 sited above gear wheel 26, this is displaced separating the two pins 102 and 103 and so freeing the sprocket drum from the decrease gear prepare. Drum 7 carrying the following blind is related by a short rod to the timing mechanism and arm 10 within the mechanism. When the blind forty four has been fully unwound from the spindle 48 the aperture blind 43 may be additional wound on the roller forty five to an adjustable extent forming a slit of predetermined measurement. On rotating the winding knob (sited above pinion 66) and the pinion 66, the blinds of the shutter are wound by rotation of the winding pinion 201 via gear wheel 64, 201 is immediately linked to the spindle carrying 45, forty nine and 50. After one revolution of the wheel 64, the pin 71 engages the pin 70 on the plate 69. The blinds are additional wound to the extent allowed by the slot 72. Until rotation is stopped by the pin 74 on the setting disc 73. The aim of the floating plate sixty nine is that when set to T or B the wheel 71 must rotate greater than 360 degrees, the slot seventy two permits this further motion.